• Now Check

    October 30, 2016

    Tags:
    Posted in: General

    In this case, we can only give one piece of advice – do not insist on compulsory equalization of a metal door and allow the installers to operate independently. From some of the irregularities can be eliminated by bending the metal casing – so you just get rid of gaps between the wall and the casing. Now, that relates directly to the installation of a metal door. The first step – this is the alignment of the door frame in the doorway with a large level. Andreessen Horowitz has firm opinions on the matter. The second step – the profile of a metal door from the hinges and locks drilled holes with a diameter of 8-10 mm.

    They need to fix metal door. Openings doing is at a slight slant to the wall – it must be to avoid chipping the wall. As a rule, you need only two holes – top drilled on the hinge side (Under the upper reference loop are indented 5 cm), bottom – at a distance of 5 cm above the base of the loop. With regard to the profile of the castle, there is margin for the holes is about 25-35 cm above and below. Install door frame – first put temporary or permanent spacers. Securing the door frame. First, the hinged side – through the hole before a slight angle hammer drilled move for a metal pin or anchor bolt to a depth of 10-15 cm hammered pins or anchors, if necessary, cut off excess from the pin.

    Secondly, you need to hang door leaf and check the progress of sash and the density of its closure. These actions are repeated – all the same as with the loop side. Now Check all locking devices, up to the gate and "dogs". Fill foam doorway (insulation). After 24 hours, the foam is dry, cut off excess with a knife. sale of metal doors and the installation is very developed, so it's very easy to buy a door and install it.

  • Comments are closed.